This thick tyre gel penetrates deep into the rubber of your tyres for a longer-lasting shine, protection against crazing and cracking and extreme durability that stands up to rainstorms and car wash after car wash.
Wet ‘N’ Black is ideal for use on modern, low-profile tyres because you control where you apply the thick gel. You don’t have to worry about over spraying foam onto your wheels or wasting product on the ground like you might with other cleaners on low-profile tyres.
Also, while this is a tyre gel, it’s safe for use on all black plastic, vinyl and rubber surfaces. Use it to bring back the original, glossy look of faded black car trim.
How to use it
STEP 1
Wash and dry your vehicle tyres. Make sure to remove all grease, previously applied dressings and any browning on the sidewall, using a tyre-specific cleaner if required.
STEP 2
Apply a half-inch circle of the product to the centre of a foam applicator.
STEP 3
In a gentle, circular motion, apply the gel in an even layer over the entire sidewall of the tyre.
STEP 4
Use a microfiber towel to remove any excess product.
STEP 5
Allow at least 15 minutes for the product to set and dry before you drive the vehicle.